Smpl 7.2: Insert Effect; 1: Setup - Korg Triton-Rack Parameter Manual

5.2–1c: UTILITY
"Delete SMPL," "Copy SMPL," "Move SMPL," "Rename
SMPL," "SMPL To Stereo," "Delete MS," "Copy MS,"
"Move MS," "Rename MS," "MS To Stereo/MS To
Mono," "Conv. To Prog," "Keyboard Disp." (1.1–3g)
104

SMPL 7.2: Insert Effect

Here you can make insert effect settings for use in Sampling
mode.
When you set "BUS" (1.1–3a) to IFX1, 2, 3, 4, or 5, the exter-
nal input sound from the rear panel AUDIO INPUT 1 and 2
jacks will be sent to IFX1, 2, 3, 4, or 5 (insert effects 1, 2, 3, 4,
5) respectively. By selecting insert effects and making set-
tings for them in this page, you can apply insert effects to
the sound of the external input, and sample the result.
For details on insert effects, refer to p.142 "8. Effect
Guide."
In Sampling mode, master effects 1 and 2 and the mas-
ter EQ cannot be used.
Insertion effect settings in Sampling mode are not
backed up when the power is turned off. If you wish to
keep the insertion effect settings, you can use "Copy
Insert Effect" (7.2–1a).
For example, you can copy the insertion effect settings
of Sampling mode to a program or combination in
order save them. When you write the program or com-
bination, the settings will be saved in internal memory.
In Sampling mode, you can use "Copy Insert Effect"
(7.2–1a) to copy these effect settings from the program
or combination back into Sampling mode and use
them.
7.2–1: Setup
Here you can select insert effects, switch them on/off, make
chain settings, and specify the pan of the sound after pass-
ing through the insert effect.
These parameters are the same as in Program mode.
gram mode "7.2–1: Setup"
7.2–1a: UTILITY
"Copy Insert Effect," "Swap Insert Effect" (PROG 7.1–1d),
"Select by Category" (PROG 7.2–1b)
Pro-
7.2–1a