2: Route (Routing) - Korg Triton-Rack Parameter Manual

Control change #93 can be used to control the Send 1
level, and #91 to control the Send 2, and modify their
respective settings. These messages will be received on
the MIDI channel specified for each timbre in the 3.1:
Ed–Param1, MIDI page.
The actual send levels are determined by multiplying
this value with the send level "S1 (Send1(MFX)), " "S2
(Send2(MFX))" (PROG 7.2–1a) for each oscillator of the
program selected for the timbre.
7.1–1b: UTILITY
"Write Combination," "Solo Selected Timbre" (1.1–1d)
For details on how to select the desired utility function, refer
to "PROG 1.1–1d: UTILITY."
Copy Insert Effect
( PROG 7.1–1c)
However, the MIDI control channel specified for "Control
Channel" of the 7.2: Ed–InsertFX, Setup page will not be
copied.
Swap Insert Effect
( PROG 7.1–1c)
However, the MIDI control channel specified for "Control
Channel" of the 7.2: Ed–InsertFX, Setup page will not be
copied.
DKit IFX Patch (DrumKit IFX Patch)
This command applies a patch to the "BUS Select" settings
of each key of the drum kit, allowing you to temporarily
change the connections to the insert effects. This command
is available only if a drum program has been selected for the
timbre and the "BUS Select" (7.1–1a) parameter is set to
Dkit. Furthermore, this command can be executed only if
the "BUS Select" (GLOBAL 5.1–3a) for the individual keys
of that drum kit are set to IFX1–5.
1 Select "DKit IFX Patch" to access the dialog box.
2 In the right side of "DrumKit IFX 1–5→", select the insert
effect to which you want to patch.
3 To execute the Drum Kit Insert Effect Patch command,
press the [F8] ("OK") key. To cancel without executing,
press the [F7] ("Cancel") key.
To restore the condition of the drum kit, execute
IFX1→IFX1, IFX2→IFX2, IFX3→IFX3, IFX4→IFX4, and
IFX5→IFX5.
46
7.1–2: Route
(Routing)
Specifies the bus to which the program used by each timbre
1–8 will be sent. Here you can also set the send levels to the
master effects.
7.1–2a
7.1–2a: Routing Map, BUS Select
Routing Map
This shows the status of the insert effects. For each insert
effect, this indicates the routing, the name of the selected
effect, the on/off status, and chain status. The effect type,
on/off status and chain status can be modified in the 7.2:
Ed–InsertFX, Setup page.
T01...8: BUS Sel
[DKit, L/R, IFX1...5, 1...4, 1/2, 3/4, Off]
You can specify the bus to which the program oscillator of
each timbre 1–8 will be sent, while viewing a map of the set-
tings.
Use the [ ], [ ] keys to select the timbre, and use the
[INC], [DEC] key or [VALUE] dial to set "BUS Select" (7.1–
1a).
These settings can also be made in "BUS Select" (7.1–1a).
7.1–2b: UTILITY
"Write Combination," "Solo Selected Timbre" (1.1–1d),
"Copy Insert Effect," "Swap Insert Effect," "DKit IFX
Patch" (7.1–1b)
7.1–2b