Korg Triton-Rack Parameter Manual page 253

4 Plug the cable into the connector as shown in the dia-
gram. Press the cable firmly in until it stops.
Do not touch any part of the circuit board other than
the connector in which the cable is being inserted.
Front panel
5 Use the four screws to attach the EXB-MOSS to the corre-
sponding brackets inside the TRITON-Rack.
Before the screws are tightened, the EXB-MOSS will
float slightly above the brackets. If at this time you
apply excessive force to the EXB-MOSS, the screws or
washers may come out.
Front panel
6 Reattach the cover by reversing the steps by which you
detached it.
7 When all steps have been completed, turn on the power
and make sure that the EXB-MOSS has been installed
correctly. ( "Checking after installation")
246
Press all the
way in
Cable
Connector
EXB-MOSS
Screw
Washer
Chassis to which the board is
being installed
Connector
3–2. Installing the EXB-SCSI
You must leave the AC/AC power supply disconnected
until you finish the entire process of removing the lid,
installing the option board or memory, and reattaching
the lid.
1 Verify the location where the EXB-SCSI will be installed.
( the lower diagram in "2. Detaching the lid")
2 Remove the EXB-SCSI from its bag.
3 Remove the two screws and washers from the two cor-
ners of the board
Be careful to save the screws that you remove. Some
models that can use the EXB-SCSI, such as the TRI-
TON/TRITONpro/TRITONproX, will require these
two screws.
Screw
4 Remove the two screws of the lid that covers the opening
for the SCSI connector, and remove the lid of the SCSI
connector opening. The two screws you removed will be
used later to fasten the EXB-SCSI in place.
The cover of the SCSI connector opening will not be
used. Be sure that it does not remain inside the TRI-
TON-Rack.
Lid (for SCSI)
5 Plug the cable into the connector as shown in the dia-
gram. Press the cable firmly in until it stops.
Do not touch any part of the circuit board other than
the connector in which the cable is being inserted.
Connector
Rear panel
Cable
Press all the way in
Remove
screw and
washer.
Washer