Multi 7.3: Master Fx; 1: Setup; 2: Mfx1; 3: Mfx2 - Korg Triton-Rack Parameter Manual

MULTI 7.3: Master FX

For details on the master effects, refer to p.146.
7.3–1: Setup
Here you can select the type of master effects, turn them on/
off, and make chain and master EQ settings.
This is the same as Program mode with the exception of
"MFX1 Control Ch," "MFX2 Control Ch," and "MEQ Con-
trol Ch." ( PROG 7.3: Ed-MasterFX)
7.3–1a
7.3–1b
7.3–1d
7.3–1a: Master FX Setup
MFX1 On/Off, MFX2 On/Off
Master Effect 1, 2
Rtn 1, 2 (Return 1, 2)
This is the same as in Program mode. Refer to "PROG 7.3–1:
Setup." However, unlike Program mode, the master effects
will be controlled by the MIDI channel specified by "MFX 1,
2 Control Ch." The control changes used are the same as in
Program mode.
MFX1, 2 Control Ch
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master effects.
G ch: The effect will be controlled on the global MIDI chan-
nel "MIDI Channel" (GLOBAL 2.1–1a).
7.3–1b: Master FX Chain
MFX Chain
Direction (Chain Direction)
[MFX1→MFX2, MFX2→MFX1]
Signal (Chain Signal)
Level (Chain Level)
This is the same as in Program mode. Refer to "PROG 7.3–1:
Setup."
7.3–1c: Master EQ Gain [dB]
Low
Mid
High
This is the same as in Program mode. ( PROG 7.3–1: Setup)
7.3–1c 7.3–1e
[Off, ON]
[000...089: name]
[000...127]
[Ch01...16, G ch]
[LR Mix, L Only, R Only]
[000...127]
[–18.0...+18.0]
[–18.0...+18.0]
[–18.0...+18.0]
7.3–1d: MEQ Ctrl
MEQ Ctrl (MEQ Control Ch)
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master EQ.
G ch: The effect will be controlled on the global MIDI chan-
nel "MIDI Channel" (GLOBAL 2.1–1a).
7.3–1e: UTILITY
"Memory Status" (1.1–1c), "Select by Category" (PROG
7.3–1d)
Copy Master Effect
( PROG 7.3–1d)
Note, the MIDI control channel specified in "Control Chan-
nel" of the MFX 1 and 2 pages will not be copied.
Swap Master Effect
( PROG 7.3–1d)
Note, the MIDI control channel specified in "Control Chan-
nel" of the MFX 1 and 2 pages will not be swapped.
7.3–2: MFX1
7.3–3: MFX2
Here you can set the parameters of the "Master Effect1" and
"Master Effect2" effects that were selected in the Setup page
( p.151).
7.3–2(3)a: UTILITY
"Memory Status" (1.1–1c)
[Ch01...16, G ch]
7.3–2a
71