Table of Contents
Advertisement
046: St.Mod. Delay
(Stereo Modulation Delay)
This stereo delay uses an LFO to sweep the delay time. The
pitch also varies. You will obtain a delay sound with swell
and shimmering. You can also control the delay time using a
modulation source.
Stereo In - Stereo Out
Left
Delay
Feedback
Delay
Right
D
-mod
Response
L/R: +/+ +/-
LFO: Tri / Sine
LFO Shape
LFO Sync
Mod Mode (Modulation Mode)
Switches between LFO modulation control and modulation source
control
a
Selects the modulation source that controls delay time
Dmod
Reversed L/R control by modulation source
b
Respons (Response)
Sets the rate of response to the modulation source
LFO Wave (LFO Waveform)
Selects LFO Waveform
c
Shape (LFO Shape)
Determines how much the LFO waveform is changed
LFO Freq (LFO Frequency)
d
Sets the LFO speed
LFO Sync
Switches LFO reset off/on
e
Src (Source)
Selects the modulation source that resets the LFO
L Phase (L LFO Phase)
Sets the phase obtained when the left LFO is reset
f
R Phase (R LFO Phase)
Sets the phase obtained when the right LFO is reset
L Depth
Sets the depth of the left LFO modulation
g
R Depth
Sets the depth of the right LFO modulation
L Dly (L Delay Time)
Sets the left delay time
h
R Dly (R Delay Time)
Sets the right delay time
L Fb (L Feedback)
Sets the feedback amount of left delay
i
R Fb (R Feedback)
Sets the feedback amount of right delay
Sets the balance between the effect and dry sounds
j
Sets the modulation amount of the effect balance
b: Dmod
When the modulation source is used for control, this parameter
reverses the left and right modulation direction.
Wet / Dry
Wet / Dry
D-mod
LFO
Modulation Mode
LFO Phase
LFO, Dmod
L/R:+/+, L/R:+/-
,
0...30
Tri, Sine
-100...+100
Fx:020
0.02...20.00Hz
Off, On
,
Off...Tempo
-180...+180
-180...+180
0...200
0...200
0.0...500.0
0.0...500.0
-100...+100
-100...+100
-Wet...-1:99, Dry, 1:99...Wet
Fx:010,
-100...+100
e: LFO Sync, e: Src, f: L Phase, f: R Phase
The LFO can be reset via a modulation source.
The "Src" parameter sets the modulation source that resets the
LFO. For example, you can assign Gate as a modulation source so
that the sweep always starts from the specified point.
"L Phase" and "R Phase" set the phase obtained when the left and
right LFOs are reset. In this way, you can create changes in pitch
sweep for the left and right channels individually.
The effect is off when a value of the modulation source spec-
ified in the "Src" parameter is 63 or smaller, and the effect is
on when the value is 64 or higher. The LFO is triggered and
reset to the "L Phase" and "R Phase" settings when the
value changes from 63 or smaller to 64 or higher.
047: St.DynamicDly
(Stereo Dynamic Delay)
This stereo delay controls the level of delay according to the
input signal level. You can use this as a ducking delay that
applies delay to the sound only when you play keys at a high
velocity or only when the volume level is low.
Stereo In - Stereo Out
Left
High Damp Low Damp
Delay
Feedback
High Damp Low Damp
Delay
Right
FB
+
Envelope
Attack, Release
Threshold
Ctrl Target (Control Target)
Selects from no control, output, and feedback
a
Pol (Polarity)
Reverses level control
Sets the level to which the effect is applied
b
Offset
Sets the offset of level control
Sets the attack time of level control
c
Sets the release time of level control
d
e
f
Sets the damping amount in the high range
g
Spread
h
Sets the width of the stereo image of the effect sound
i
Wet / Dry
Spread
Wet / Dry
Out
Control Target
None, Out, FB
+, -
0...100
0...100
1...100
1...100
0.0...680.0ms
0.0...680.0ms
-100...+100
0...100%
Fx:043
0...100%
-100...+100
Fx:043
Dry, 1:99...99:1, Wet
-100...+100
177
Advertisement
Chapters
Table of Contents
