2-8.
Front Panel
2-8-1.
Front Panel Assembly
Preparation
1.
Remove the battery lid. (Refer to
2.
Remove the bottom cover. (Refer to
3.
Remove the inside panel assembly. (Refer to
4.
Remove the outside panel assembly. (Refer to
5.
Remove the top panel assembly. (Refer to
Procedure
1.
Disconnect the flexible board from the connector CN103 on the SWC-54 board.
2.
Disconnect the harness from the connector CN104 on the SWC-54 board.
3.
Remove the two tapping screws (2 x 5) to detach the front panel assembly.
Tapping screw
(2 x 5)
Tapping screw
(2 x 5)
4.
Note
When installing the Front panel assembly, fit the ND filter knob with the lever.
Install the removed parts by reversing steps of removal.
2-8-2.
SW-1559 Board/SW-1573 Board
Preparation
1.
Remove the battery lid. (Refer to
2.
Remove the bottom cover. (Refer to
3.
Remove the inside panel assembly. (Refer to
PMW-200/PMW-EX280
"2-2. Lithium
Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
"2-5-1. Outside Panel
"2-6. Top Panel
Assembly".)
Lever
CN104 (SWC-54 board)
Harness
"2-2. Lithium
Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
Washer".)
Assembly".)
Assembly".)
CN103 (SWC-54 board)
Flexible board
ND filter knob
Front panel assembly
Washer".)
Assembly".)
2-16