Table of Contents
Advertisement
ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
3.6
Deleting an ISaGRAF Project from the Controller
There may be some reason you need to delete the ISaGRAF program from the
controller. TO begin this, as the way you change the baud rate before.
: Change the selection
First, power off the VP-2117 PAC, then press and hold on the F1 and F6 button
and then power it up. In the setup mode, you will see ,: Change the
Selection and Enter Key is OK .
Press the
screen, and then press
Deleting An
ISaGRAF Project
Back Key to Quit
Press
Project screen. After deleting the ISaGRAF project, it will return to the
selection screen.
Deleted Project
Back Key to Quit
After complete the setting, please press
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
,: Change the
F1
Selection
Enter Key is OK
Waiting any key
or
button to switch to the Deleting An ISaGRAF Project
to enter the setup screen.
to confirm the deletion, at this point, you will receive the Deleted
VP-2117 Getting Started, Apr. 2010, V1.0
: Confirm
F6
Press Enter Key
Delete Project
Back Key to Quit
Deleting An
ISaGRAF Project
Back Key to Quit
to quit the setup mode.
: Cancel
3-6
Advertisement
Table of Contents
