ICP DAS USA VP-2117 Getting Started page 38

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
Step 2: Initialize I/O module
If the module is a new one, factory have set a default settings (as table 1) for user‟s
convenient. If you don‟t know the configuration of the module, please initialize the
I/O module (as table 2).
The default state from factory (table 1):
I/O Module
Address
Baud rate
Checksum
Protocol
The initial state after initialization (table 2):
I/O Module 7000 series (I-7000 and M-7000)
Address
Baud rate
Checksum
Protocol
★To initialize I-7000 module is to wire connect the INIT* to GND and Power on the
module. After initialization, the module will become initial state.
★To initialize I-87K (high profile) module, please switch the DIP switch of
I-87K4/5/8 /9. For example, switch Dip-1 to ON and restart I-87Kn, the Slot1
will setup to initial. When use I-87K5/9 you must start from the second slot
(slot1), CAN NOT use the first slot (slot0).
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
I-7000
1
9600
Disabled
DCON Protocol Modbus Protocol DCON Protocol
9600
Disabled
DCON Protocol
VP-2117 Getting Started, Apr. 2010, V1.0
M-7000
1
9600
Not defined
0
87K series
1
115200
Disabled
87K series
0
115200
Disabled
DCON Protocol
3-16