Intermec EasyCoder PF2i User Manual page 53

To change alert settings:
• Choose Enable or Disable from the Setting drop-down list.
• Specify a Delay Repeat in the entry fi eld.
• Select seconds or occurrences in the Delay Unit drop-down list.
• Enter a message in the Message entry fi eld.
When you have made the necessary changes, click Submit Settings to
send the changes to the printer. For more information on Alert settings,
see the next table.
Note: Some alerts are supported by Fingerprint only.
Alert Settings
Alert Name
Label Not Taken
(Fingerprint only)
Cutter Error
Head Lifted
Out of Ribbon
Out of Paper
Ribbon Low
Paper Low
(PM4i option)
Pause Mode
Setup Mode
Error Condition
(Fingerprint only)
Application Break
(Fingerprint only)
EasyLAN User's Guide
Chapter 4 — Using the EasyLAN Web Browser Interface
Sent When
Printed label is not taken from the printer. Th is applies to
label and ticket media types and requires an optional label
taken sensor (LTS).
Error related to the label cutter occurs.
Printer job is sent to the printer while the printhead is lifted.
Th ermal transfer ribbon is selected and printer is out of
ribbon.
Printer is out of media.
Th e diameter of the remaining roll of ribbon is lower than a
specifi ed value. Th e value can be specifi ed under the Media
section.
Th e diameter of the remaining roll of media is lower than a
specifi ed value. Th e value is specifi ed in the Media page. Only
shown if the sensor is installed.
Th e diameter of the remaining roll of media is lower than a
specifi ed value. Th e value is specifi ed in the Media page. Only
shown if the sensor is installed.
Printer has been placed in Setup Mode (for example, after you
press the Setup key on the printer's internal keyboard).
An error occurs in a running Fingerprint application. Error
does not have to be critical to the print job for this alert.
A running Fingerprint application is interrupted manually or
because of an error.
39