EXUP CABLE ADJUSTMENT
1
•~gs
I •
I
Perform this test immediately so that the
s,rvo motor is not damaged.
eCheck the EXUP valve.
• Connect the servo motor coupler.
**********************************
4.Check:
• EXUP cable free play@
EXUP cable free play:
1.5 mm (0.059 in) or less
5.Adjust:
• EXUP cable free play
**********************************
•
•
•
Adjusting steps:
•
• Loosen both locknuts G).
3- 40
elnsert a 4 mm (1.57 in) pin through the
notch of the pulley and into the hole.
•Turn both adjusters
®
counterclockwise
until there is no cable free play.
eTurn both adjusters 1/2 of a turn clock-
wise.
• Tighten both locknuts and then remove
the pin.
**********************************
6.lnstall:
• EXUP valve cover
Bolt (EXUP valve cover):
10 Nm (1.0 m • kg, 7.2 ft• lb)
·l!t:·
,·l /
•
••
'
••
1
.,
S+
~
'
.
j