Yamaha YZF1000RJ Service Manual page 289

HYDRAULIC CLUTCH
'CHAS,~,
Hydraulic clutch components rarely require
disassembly. DO NOT:
• Disassemble components unless abso-
lutely necessary.
• Use solvents on internal clutch compo-
nents.
• Use spent clutch fluid for cleaning (use
only clean clutch fluid).
• Allow clutch fluid to come into contact
with the eyes, as this may cause eye
injury.
• Splash clutch fluid onto painted surfaces
or plastic parts, as this may cause dam-
age.
• Disconnect any hydraulic connection, as
this would require the entire clutch sys-
tem to be disassembled, drained,
cleaned, properly filled and bled after
reassembly.
•
•
•
DISASSEMBL V
NOTE:
Before disassembling the clutch release cyl- •
inder or master cylinder drain the master
7 - 34
cylinder and clutch hose of their fluid.
Clutch release cylinder
1.Remove:
• Union bolt
CD
• Copper washers ®
• Clutch hose @
• Clutch release cylinder @
• Dowel pins
2.Remove:
• Dust seal
CD
• Piston (clutch release cylinder)®
• Spring@
• Piston seal @
NOTE: - - - - - - - - - - - - -
Blow compressed air into the hose joint
opening to force out the piston from the
clutch release cylinder body.
•
•
•