Table of Contents
Advertisement
DRIVE CHAIN SLACK ADJUSTMENT
~
----------------------------
I
IANDSJP
1 •~
I
·\
3. Loosen:
• Axle nut G)
4.Adjust:
• Drive chain slack
**********************************
Adjustment steps:
• Loosen both locknuts
®·
• Turn the adjuster. @ in or out until the
specified drive chain slack is obtained.
Turning in:
Drive chain slack is
increased.
Turning out:
Drive chain slack is
decreased.
NOTE: - - - - - - - - - - - -
• To maintain the correct axle alignment
turn each adjuster exactly the same
amount. (There are marks@ on each side
of the swingarm. When adjusting the
slack for the proper alignment use these
marks as reference points.)
• Before tightening the axle nut to specifica-
•
•
•
tion, make sure that there is no clearance
•
at the adjuster or the swingarm end on
3- 54
both sides. Push the wheel forward to
check for any clearances.
~ .
Axlenut:
~~
150 Nm (15.0 m • kg, 110
ft•
lb)
•Tighten the locknuts.
**********************************
•
•
•
.,
• -...,~--.. ~ - . [ .
,..:.,, '
·,_,,.,
;.i•..'.?_ ••
~~
Advertisement
Table of Contents
Troubleshooting
