Yamaha YZF1000RJ Service Manual page 197

•
A
•
•
B
•
•
•
•
ENGINE ASSEMBLY AND ADJUSTMENT
I
ENG
I \al
4- 63
a.Tighten:
• Bolts (upper crankcase)
• Bolts (lower crankcase)
(follow the proper tightening sequence)
Bolt (crankcase):
* M9 (G) .. @, @):
32 Nm (3.2 m • kg, 23 ft • lb)
x MB
(@ .. @, @), @, @, @) .. @,
@and®)--@):
24 Nm (2.4 m • kg, 17 ft• lb)
6
M6 (@,@),@,@,@,@, ®):
12 Nm (1.2 m • kg, 8.7 ft• lb)
[Al Upper crankcase
[ID Lower crankcase
NOTE: _ _ _ _ _ _ _ _ _ _ _ _
• Lubricate the bolt threads
(M9)
with
molybdenum disulfide oil.
• Lubricate the bolt threads (MS and M6)
with engine oil.
• Tighten the bolts in the tightening
sequence cast on the crankcase.
• Install the bracket (radiator stay) on bolt
No.@and@ .
• Install the washer on bolt No.
(J)
~
@.
• Install a copper washer on bolt No. @).
9.lnstall:
• Bearing retainer (main axle) G)
Use a torx wrench (T30).
~
Bolt (bearing retainer):
~
10 Nm (1.0 m • kg, 7.2 ft• lb)
10.lnstall:
• Pickup coil G)
(with the O-ring)
• Pickup coil lead holder
®
• Crankshaft end cover (right) @
• (with the O-ring)
NOTE: - - - - - - - - - - - -
Apply engine oil to the O-ring of the pickup
coil.
Bolt (pickup coil):
10 Nm (1.0 m • kg, 7.2
ft•
lb)
Bolt (lead holder):
10 Nm (1.0 m • kg, 7.2
ft•
lb)
Screw (crankshaft end cover):
7 Nm (0.7 m • kg, 5.1 ft• lb)