Yamaha YZF1000RJ Service Manual page 212

ENGINE ASSEMBLY AND ADJUSTMEIVT
I
ENG
I '\al
4- 78
Procedure 2.
e
Insert the pin
®,
use it to position the
pick-up rotor
G),
then install the bolt@.
Part No:@ 4U8-81673-10 or 33M-81673-10
(6)
91317-08030
@ 93604-08071
• Turn the crankshaft counterclockwise.
•Turn the crankshaft counterclockwise and
align the "T" mark
CD
with the stationary
pointer (ID when the #1 piston is at TDC .
·"'
----------
While installing the camshafts do not turn
the crankshaft. Damage or improper valve
timing will result.
• Lubricate the camshaft bearing surfaces,
cam lobes and cam journals.
Recommended lubricant:
__,. Molybdenum disulfide oil
eFirst, install the exhaust camshaft@ then
install the intake camshaft@.
NOTE: - - - - - - - - - - - -
• Be sure to install the camshafts in the
right place: 3 lobes~= intake camshaft, 2
lobes
rn:J
= exhaust camshaft
• Make sure that the timing marks Qi) on the
camshaft face upward.
• Keep the timing chain as tight as possible
on the exhaust side.
• Remove the wire on the timing chain.
- - ; , , ; : , . • · .:.., . ... ,,_.;z:
u·::-:--jt,ji
ft.ffl ~ . . .
X•.
$.¾ - - - - - - - - - -
Do not rotate the camshaft, as damage
could occur to the pistons and valves.
• Install the dowel pins.
elnstall the camshaft caps.
•Align the camshaft timing marks Qi) with
the camshaft cap marks
CD.
• Tighten the camshaft cap bolts.
Bolt (camshaft cap):
10 Nm (1.0 m • kg, 7.2 ft• lb)
•
•
•
•
•
•
•