Chapter 2 — Using the Intermec Gateway in a Native Environment
Starting the Native Applications
44
This example walks you through the terminal screens to show
you how to configure and enable one of the terminal sessions for
Host/Server A, Native communications, terminal number 42,
and RF host name MYHOST.
1) Host A
2) Host B
3) Host C
Enter Unit
Number:
42
Native
Unit # 42
Enter Host Name
MYHOST
1)Native
2)3270
3)5250
4)VT220
1)Enabled
2)Disabled
You may still need to configure your devices to communicate
with the WTP network and access points. For help, see your
device user's manual and your access point user's manual.
After you have loaded the client, configured your devices, and
started your Intermec Gateway, you can run the Native
application on a UDP Plus or WTP device.
Intermec Gateway User's Guide