Installing The Intermec Gateway Licenses; Opening The Intermec Gateway Home Page - Intermec CN2B User Manual

Chapter 2 — Using the Intermec Gateway in a Native Environment

Installing the Intermec Gateway Licenses

Opening the Intermec Gateway Home Page

28
Before you can use your Intermec Gateway in a Native
environment, you need to purchase and install an Intermec
Gateway license for each session that will connect through the
Intermec Gateway. For example:
• If a Trakker Antares terminal is configured to run two
separate TE 2000 sessions over the UDP Plus network, it uses
two of the possible 300 connections and requires two licenses.
• If a WTP device is configured to support two sessions (for
example, connecting to two hosts), that WTP device will
require two licenses.
For help installing the licenses, see the Intermec Gateway License
Instructions (P/N 072960) that shipped with the Intermec
Gateway license disk.
Note: Before you install the licenses, Intermec allows one device
to connect to the Intermec Gateway for development purposes
only.
Before you can open the Intermec Gateway home page, you
need to install the Intermec Application Server and assign the IP
address. For help, see the Intermec Application Server User's
Guide.
Note: If you access the Internet by using a proxy server, you
MUST add the IP address of the Intermec Application Server to
your Exceptions list. The Exceptions list contains the addresses
that you do not want to use with a proxy server.
To open the Intermec Gateway home page
1 Start Internet Explorer on your PC.
2 In the Address field, type:
http://serverip
where serverip is the IP address for the Intermec Application
Server.
Intermec Gateway User's Guide