Intermec CN3E Instructions
Dust clip
Hide thumbs
Also See for CN3E:
- Supplementary manual (12 pages) ,
- Quick start manual (2 pages) ,
- Replacement instructions (2 pages)
Advertisement
Table of Contents
Use these instructions to attach the dust clip to both the CN3 and CN3e
mobile computers. The dust clip seals out dust and airborne particles from
the CN3NI in Division 2 Class II and III environments.
CN3NI Computers: This illustration shows the CN3 Series Mobile Computers with
the dust clip properly installed.
Make sure the dust clip completely covers the docking
connector on the CN3 or CN3e and that it snaps into place.
Dust Clip Instructions
CN3NI
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Intermec CN3E
Summary of Contents for Intermec CN3E
- Page 1 Use these instructions to attach the dust clip to both the CN3 and CN3e mobile computers. The dust clip seals out dust and airborne particles from the CN3NI in Division 2 Class II and III environments. CN3NI Computers: This illustration shows the CN3 Series Mobile Computers with the dust clip properly installed.
- Page 2 CN3NI Dust Clip Instructions *943-167-001* P/N 943-167-001 Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2008 Intermec Technologies Corporation. All rights reserved.
Need help?
Do you have a question about the CN3E and is the answer not in the manual?
Questions and answers