Trakker Antares Udp Plus Terminals - Intermec CN2B User Manual

Run Program C:VTXXX_D.BIN
*/O/OC/ZVTXXX%OD/NBIN*
*//C:VTXXX_D.BIN*
Run Program C:PLX5250.BIN
*/O/OC/ZPLX5250/NBIN*
*//C:PLX5250.BIN*
Run Program C:PLX3270.BIN
*/O/OC/ZPLX3270/NBIN*
*//C:PLX3270.BIN*
Intermec Gateway User's Guide
Chapter 1 — Using the Intermec Gateway in a Telnet Environment

Trakker Antares UDP Plus Terminals

To run the TE 2000 terminal emulation application, simply
press q to turn on the Trakker Antares terminal if your
terminal is configured to use the TE 2000 application.
To run the legacy Intermec Telnet TE clients on your Trakker
Antares terminals with firmware v6.20 or earlier, you can either
scan one of the bar codes below or you can use the TRAKKER
Antares 2400 Menu System.
To run VT/ANSI TE
• Scan this bar code:
To run TN5250 TE
• Scan this bar code:
To run TN3270 TE
• Scan this bar code:
To use the TRAKKER Antares 2400 Menu System to run TE
1 On your terminal, access the TRAKKER Antares 2400 Menu
System by scanning this bar code:
TRAKKER Antares 2400 Menu System
*..-.*
*..-.*
21