Toshiba GR200 Series Instruction Manual page 1351

Test for control application
14.4.3
Synchronizing check test (SYNC01,02-Test)
(i)
Settings [SYNC01-Test] and [SYNC02-Test]=On allows to have test synchronized conditions.
Control and monitoring application: Synch check for difference network
See Chapter
Test for BI and BO circuits
14.4.4
Binary input circuit test (SLOT*BIxx-SET)
(i)
Setting [SLOT*-BIxx-SET] allows to have a virtual input at a binary input circuit.
Binary output circuit test (SLOT*BOxx-SET)
(ii)
Setting [SLOT*-BIxx-SET] allows to have a virtual output at a binary input circuit.
Note: For the BI and BO test operation, see Chapter
separately.
Test for mode change (MDCTRL)
14.4.5
The function is provided to detect a test mode. For more information, see Chapter
control function: Mode control function
Signal monitor
14.4.6
The function is provided in order that the user can observe IED internal signals. For more
information, see Chapter
separately.
LED light test
14.4.7
The user can perform LED lighting test by pressing the keys ◄ and ►. Press the both keys on
the front panel for a few seconds. If there is no problem, all LEDs will be lit.
, separately.
Technical description: Human machine interface: Monitoring jacks
- 1330 -
6F2S1915 (0.46)
User interface: Test sub-menu
GRZ200 (Soft 031 & 032)
.
,
General
,