Toshiba GR200 Series Instruction Manual page 1164

LAN operation
LAN address (IP address)
11.2.1
The IED can have the communication with "Transmission Control Protocol/Internet Protocol
(TCP/IP)". The user can set the information about IP addresses and other TCP/IP. Table 11.2-1
shows the setting items provided for the LAN†.
These setting values have been included in the CID file of the IEC61850. When the IED starts
up and if values except for the 0.0.0.0 values or default are set in the CID file, the CID
information is taken into the IED.
As the setting values have been included in the CID file, the user can define these values with
the engineering tool (GR-TIEMS). If the user wishes to modify those and the IEC61850 is used
to communicate, the user can change those with the GR-TIEMS. The user is required to write
both of setting values and IEC61850-CID file into the IED.
Ports Setting items
IPADDRESS1
Port A
SUBNETMASK1
at C11
GATEWAY1
IPADDRESS2‡
Port B
SUBNETMASK2‡
at C12
GATEWAY2‡
When the user wishes to change addresses, enter the new address into the IED using the LAN
setting sub-menu (Figure 11.2-1). The setting menu is provided for the user to change the
addresses‡.
Figure 11.2-1 Local LAN setting menu (on IED screen)
†Note: For the location of the LAN communication modules, see Chapter
description: Signal processing and communication module
‡Note: IP address setting is dependent on the selection of the communication protocols.
Table 11.2-1 TCP/IP settings at LAN modules
Range
0.0.0.0–255.255.255.255
0.0.0.0–255.255.255.255
0.0.0.0–255.255.255.255
0.0.0.0–255.255.255.255
0.0.0.0–255.255.255.255
0.0.0.0–255.255.255.255
LAN
10:48
IPADDRESS1
192.168.1.11
SUBNETMASK1
255.255.255.1
GATEWAY1
192.168.1.1
- 1143 -
Setting meaning
First IP address
Subnet mask
Default gateway
Second IP address
Subnet mask
Default gateway
1/6
+
+
+
.
6F2S1915 (0.46)
Default value
192.l68.1.11
255.255.255.0
192.168.1.1
192.l68.1.12
255.255.255.0
192.168.1.1
Technical
GRZ200 (Soft 031 & 032)