Toshiba GR200 Series Instruction Manual page 1048

Setting
8.3.7
DISTURB_REC(Function ID: 200401)
Setting items
Record Time
Pre-fault Time
Sampling Rate
Trip Trig.SW
DISTURB_REC(Function ID: 200401)
Setting items
Binary Signal1
Binary Sig.Name1
Binary Signal2
Binary Sig.Name2
Binary Signal3
Binary Sig.Name3
......
......
Binary Signal256
Binary Sig.Name256
DRT_LP(Function ID: 4B0001)
Setting items
OC-DRT-EN
OC-DRT
EF-DRT-EN
EF-DRT
UV-DRT-EN
UV-DRT
UVS-DRT-EN
UVS-DRT
Range
Unit
0.1 - 10.0 s Time for disturbance recording
0.1 - 10.0 s Pre-fault time
7.5 / 15 deg Sampling electrical degree for recording
Off / On – Operation with the TRC trip command
Range
Unit
(Preferred DataID) – Logic signal1 for the operation
(Preferred name) – Name of the logic signal1
(Preferred DataID) – Logic signal2 for the operation
(Preferred name) – Name of the logic signal2
(Preferred DataID) – Logic signal3 for the operation
(Preferred name) – Name of the logic signal3
...... – ......
...... – ......
(Preferred DataID) – Mode setting for the detection
(Preferred name) – Name of the trigger signal768
Range
Unit
1A rating 5A rating
Off / On – Disturbance Record Trigger OC-DRT enable
0.10 - 0.50 - OC-DRT relay operating value
A
50.00 250.00
Off / On – Disturbance Record Trigger EF-DRT enable
0.10 - 0.50 - EF-DRT relay operating value
A
50.00 250.00
Off / On – Disturbance Record Trigger UV-DRT enable
5.0 - 130.0 – UV-DRT relay operating value
Off / On – Disturbance Record Trigger UVS-DRT enable
5.0 - 130.0 V UVS-DRT relay operating value
- 1027 -
6F2S1915 (0.46)
Contents
Contents
Contents
GRZ200 (Soft 031 & 032)
Default
Note
3.0
0.3
15
On
Default
Note
See Setting table
in this section
Default
Note
1A 5A
Off
1.00 5.00
Off
0.20 1.00
Off
0.20
Off
51.0