Toshiba GR200 Series Instruction Manual page 1337

Hide thumbs Also See for GR200 Series:

White-plastic-sheets for IED case sides

When the user wishes to mount an IED case in the 19-inch rack, the user should have

arrangements and preparations of the IED in advance. There are two types with regard to the

structures of IED cases.

Rack mounting type: flanges have to be screwed and fixed on the case, and countersunk screws

are provided for them. When wishing to place the IED case in a 19-inch rack, put white-

plastics-sheets on the countersunk screws to cover up (see Figure 13.3-7); they are bundled in

its package. Detach the flange from the case if combining cases is required with a mounting

kit. Remind that the user needs to put the white-plastic-sheet over the countersunk screws on

Left silver- flange

Figure 13.3-7 Covering the screw holes with white plastic sheets

Note: When the case is ordered in 1/1 size one; the flange is integrated so that the

countersunk screws and white-plastic-sheets are not provided.

Note: For more information about how to mount a case in a rack, see

handbook for rack mounting, cable work, etc.

mounting kit by ordering (

Flush-mounting type: flanges are integrated at the both sides of the case. Thus, the white-

plastics-sheets are not bundled.

see Appendix: Ordering

6F2S1915 (0.46)

Right silver- flange

Installation

The user can get a

GRZ200 (Soft 031 & 032)