Advertisement
4
PREPARE PENDULUM STUNT
Attach the Marble Catch to a 200 mm shaft. Insert
other end of shaft to the left side of the Pendulum.
Next attach an Arm Holder B to a 65 mm shaft with
an Arm Lock and add the Counterweight to the post
of Arm Holder B. Finally, attach the 65 mm shaft to
the right hand side of the Pendulum.
5
SHAFT ASSEMBLY
Step 1: Slide Arm Holder B of each arm on to a shaft and lock in
place with Arm Lock. Refer to the next pages for orientation and
location of each arm.
Step 2: Attach each arm as shown in step 1 with the orientation
and location shown on the following pages. In later steps the letter
of each shaft and number of each arm will guide in the installation
of the rails. For example Arm A-3 is 104 mm from the base.
Shaft illustrations are approximately 37% of actual size. All shaft
measurements are in Millimeters.
NOTE:
The shafts listed below contain no arms and are not included in the drawings.
Shafts: I, J, L, M, N, O, W, X, Y, Z, AX, AY, and AZ
Page 8
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
NOTE:
The Counterweight is adjustable, if the
pendulum stunt is not working, try
moving the weight to different positions.
ARM TYPE REFERENCE
Arm A
Arm B
Arm C
Arm D
See-Saw Arm
Advertisement
