Download Print this page

Spacerails Level 9 Instruction Booklet page 6

Advertisement

ELEVATOR B
Step 1: Place a 391 mm shaft in
the white hole on the Power Box.
Step 4: Slide each Elevator Ring
into position on the support
shafts right-side up.
Page 6
NOTE:
Install the first Elevator
Helix piece male side
up and rotate it until
it slides in place and
engages with driver at
the base of Power Box.
Step 2: Connect Elevator Helix
pieces together with the male part
facing up to fill the shaft.
335 mm
30 mm
0 mm
Step 5: Place the Elevator Cover
onto the top of the elevator
assembly.
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Step 3: Once the corkscrew
is built, attach three 391 mm
support shafts to the Power Box.
Step 6: Attach Rail Clips to
each Elevator Ring as shown.

Advertisement

loading