Table of Contents
Advertisement
Quick Links
LEVEL 2
PRODUCT AND CONSUMER WARNING
CHOKING HAZARD: This product contains small parts and is not intended for children under 3.
• This product is intended for users 8 years of age and older.
• To avoid choking, keep small parts away from children.
• Use caution—this product contains parts with sharp edges.
• To avoid potential damage to the product, only insert the included marbles into the elevator.
Advertisement
Table of Contents
Related Manuals for Spacerails Level 2
Summary of Contents for Spacerails Level 2
- Page 1 LEVEL 2 PRODUCT AND CONSUMER WARNING CHOKING HAZARD: This product contains small parts and is not intended for children under 3. • This product is intended for users 8 years of age and older. • To avoid choking, keep small parts away from children.
-
Page 2: Parts Included
Pen or Marker 3 AA Batteries (newer models) or 1 C Battery Rail Coupling Marble Rail Rail Clip 4 PCS 2 PCS 10,000 mm Ruler (in Centimeters) Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 2... -
Page 3: Prepare Components
Attach the arm to the shaft and the shaft to the base prior to attaching the round receiver side of the Arm Sheath to the See-Saw Arm. Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 3... -
Page 4: Base Assembly
Helix pieces together with is built, attach three support the Power Box. the male part facing up to shafts to the Power Box. fill the shaft. Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 4... - Page 5 Rail Clips on the bottom two Elevator Rings. Step 9: Firmly seat the posts from the Power Box in the holes on the base. Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 5...
-
Page 6: Shaft Assembly
60% of scale. Holder B Shaft A Shaft B Shaft C 182 197 Shaft D Shaft E 281 300 SHAFT TO BASE ORIENTATION BACK OF BASE FRONT OF BASE Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 6... - Page 7 Tip: To help avoid do-overs and using too much rail, cut generously (slightly longer than required) to begin with. You can always cut a long rail shorter. Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 7...
- Page 8 Rails should extend into the elevator enough to catch the Marble. Keep incline as smooth as possible to avoid losing speed or contact with rails. Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 8...
- Page 9 A-6 then around to arm C-6, E-2, and D-2. Repeat for second rail and move to next illustration and step 2 on the next page. Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 9...
- Page 10 C-2, E-1, and back to arm D-1. Finish at the Rail Clip on the lower right elevator entrance. Repeat step for second rail. Fine Tune: Once each rail section is completed run a Marble down your course and make sure it travels well. Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com Page 10...
- Page 11 NOTE: Congratulations on completing Spacerails Level 2! Fine tune the rails and see how many marbles you can get going at the same time. If the marbles are coming into the elevator too quickly it may knock other marbles already in the tower out.
- Page 12 Seaich Corporation 1910 West 1040 South Salt Lake City, UT 84104 (833) 732-4242 orders@seaich.com Spacerails LLC www.spacerails.com...