Advertisement
DOUBLE LOOP STUNT SUSPENDED SHAFTS
Step 1: Attach shaft I to the arms H-3 and C-3. Attach shaft
J to the arms H-1 and C-1. This creates a box shape when
observing from the front of the base.
Step 2: Attach shaft L to the arms A-5 and K-5. Attach shaft
M to the arms A-1 and K-1. This creates a box shape when
observing from the back of the base.
Step 3: Attach shaft E centered between shafts L and I using
arms E-1 and E-8. The arms of shaft E should face down.
Step 4: Attach shaft D centered between shafts J and M using
arms D-1 and D-8. The arms of shaft D should face up.
Step 5: Attach shaft F between shafts H and K 100 cm above
the base using arms F-1 and F-8. The arms of shaft F should
face to the right. Attach F-2 to shaft V for additional support.
Step 6: Attach shaft G between shafts A and C 100 cm above
the base using arms G-1 and G-8. The arms of shaft G should
face to the left.
Step 7: Attach shaft R to arm G-3 and rest on working surface.
Shaft R is not over the base.
STAIR STUNT SUSPENDED ARMS
Step 1: Take stair stunt part A and slide into position so that it can connect
to arms S-3, V-3 and R-4. This is the upper portion of the stair stunt.
Step 2: Take stair stunt part B and move into position so that it can connect
to arms S-1, V-3, R-2 and R-1. This is the lower portion of the stair stunt.
Stair Stunt A
Stair Stunt B
Page 18
S
V
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
R
Advertisement
