Spacerails Level 9 Instruction Booklet page 29

SUPER DROP LOOP AND ELEVATOR TRANSFER SECTION
AU -1
BF -1
AT -1
STEP 1: Attach rail T (188 cm) to the back side of the Rail Splitter and connect to arm AW-8. Then proceed
down through the funnel stunt and attach at arm BH-1 and loop up to arm BF-1. Finish the loop by passing
down through arm AV-1 and out to arm AU-1. Finish by creating a banked turn that passes through arm AT-1
and ends at the bottom Elevator Ring on the left side of elevator A. The drop should be very steep but still
allow the Marble to maintain contact to the rails.
STEP 2: Add rail S (175 cm) to the Rail Clip on the top Elevator Ring on the right side of elevator A. Continue
through arms AW-6, C-4, R-3, V-2, BE-2 and end at the second Elevator Ring on the right side of elevator B.
Image showing I–Step 1
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
BE -2
AV -1
BH -1
AW -8
AW -6
Image showing I–Step 2
V -2
C -4
R -3
Page 29