Advertisement
3
ELEVATOR ASSEMBLY
ELEVATOR A
Step 1: Place a 300 mm shaft in
the white hole on the Power Box.
NOTE:
Elevator Rings are
right side up when
tabs in red are on
the top.
Step 4: Slide each Elevator Ring
into position on the support
shafts right-side up.
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
NOTE:
Install the first Elevator
Helix piece male side
up and rotate it until
it slides in place and
engages with driver at
the base of Power Box.
Step 2: Connect Elevator Helix
pieces together with the male part
facing up to fill the shaft.
240 mm
40 mm
0 mm
Step 5: Place the Elevator
Cover onto the top of the
elevator assembly.
Step 3: Once the corkscrew
is built, attach three 300 mm
support shafts to the Power Box.
Step 6: Attach Rail Clips to
each Elevator Ring as shown.
Page 5
Advertisement
