Advertisement
ELEVATOR C
2 cm
Step 1: Insert a 300 mm
shaft first into a Shaft Cap
and then into the center
hole of an Elevator Cover.
Add the Shaft Clip 2 cm up
from the base.
Step 5: Place the Elevator
Cover onto the top of the
elevator assembly.
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Step 2: Connect
Elevator Helix pieces
together with the
male part facing up
to fill the shaft.
Step 6: Attach Rail
Clips to each Elevator
Ring as shown.
Step 3: Once the
corkscrew is built,
attach three 300 mm
support shafts to the
Elevator Cover.
ADDING GUARDS: Repeat this step for all
three elevators that have been built.
NOTE:
The Marble may
fall out of the
elevator if it
enters too fast.
Add Elevator Guards to the right of each
Rail Clip installed to the bottom two
Elevator Rings.
185 mm
75 mm
0 mm
Step 4: Slide each
Elevator Ring into
position on the
support shafts
right-side up.
Page 7
Advertisement
