Advertisement
UPPER STAIR AND ROUND ABOUT EXIT SECTION
A -11
BE -3
AE -8
AV -8
AE -7
A -10
R -5
AV -8
S -4
AV -2
AG -1
AG -3
AH -1
AH -3
AI -1
AI -2
AJ -3
AJ -1
AW -3
STEP 1: Starting at arm AE-8 connect rail W (550 cm) as once continuous rail connecting through A-11, R-5,
S-4, BE-3, AE-7, A-10, AJ-1, and AJ-3. At this point create a loop that will drop the Marble on the rail below it
that will be on shaft AI. After creating the loop at arm AJ-3 work back to the top with arms AJ-1, A-10, AE7,
BE-3, S-4, R-5, A-11, and AE-8 .
STEP 2: Finish the upper stair step stunt by attaching rail G (34 cm) to arms AI-1 and AI-2 as one continuous
loop. Attach rail G (34 cm) to arms AH-1 and AH-3 as one continuous loop. Add another rail G (34 cm) to arms
AG-1 and AG-3 as one continuous loop. Make sure to add the Rail Clips and an open loop that drops the Marble
to the rails below it. (See illustration 1 on page 22)
STEP 3: Attach rail N (75 cm) to the bottom left Rail Clip of elevator C. Then connect rail through arms AW-3
and AV-2 finishing with the Rail Clip facing the back on elevator A's second Elevator Ring.
Image showing F–Step 1 and 2
Image showing F–Step 3
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Page 26
Advertisement
