Advertisement
STAIR STEP LOWER SECTION
P -1
AC -1
STEP 1: Attach rail R (100 cm) to Rail Clip of bottom Elevator Ring facing the back of the base. Connect rail
through arms AC-1, P-1, AE-1, K-2, and A-2. Repeat step for second rail.
STEP 2: Attach rail P (90 cm) beginning at arm AE-3 that connects to K-4, A-4, and ends at AO-1. Allow rail to
extend at least 6 cm beyond arm AE-1. See reference photo on next page.
STEP 3: Refer to illustration 1 below. Start adding rails to the stair step stunt by attaching rail G (34 cm) to arms
AN-1 and AN-4 as one continuous rail. Remember to leave an open loop on one side so that the marble may
fall trough and land on the rails below it. Add Rail Clips as shown to maintain the shape of the rail.
STEP 4: Repeat step 3 for shaft AM and AL by connecting rail G (34 cm) to arms AM-1 and AM-4 as one
continuous rail. Connect rail G (34 cm) to arms AL-1 and AM-3 as one continuous rail. Make sure to add the Rail
Clips and an open loop that drops the Marble to the rail below it.
STEP 5: Refer to illustration 2 below. Attach rail H (43.5 cm) to arms AK-1 and AK-3 leave an open loop on one
side so that the Marble may fall through and land on the rail below it. Add two additional rail B (5.5 cm) above
the rail just added using Rail Clips as shown. This rail cradle will help keep the Marble on the rail. The upper
section of the stair step stunt will be completed later.
Illustration 1
Page 22
AE -1
AE -3
AK -1
AK -3
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
K -2
K -4
AM -1
AL -1
AM -4
AL -3
Illustration 2
A -2
A -4
AN -1
AN -4
AO -1
Advertisement
