Otto Bock 8E33 Series Instructions For Use Manual page 23

7.2 Torch
(for terminal devices with built-in torch)
Inserting the batteries (2x CR2032)
INFORMATION
With a bilateral amputation, torch battery replacement depends on the prosthesis, the anatomic­
al conditions and the patient's experience with the prosthesis system. In principle the support of
another person can also be obtained for battery replacement.
To insert the batteries, complete the following steps:
7.3 Opening the terminal device in an emergency
7.4 Changing the 8E33=9* terminal device
Separating the terminal device from the socket
1) Turn the prosthesis off with the button in the charging receptacle (prosthetic socket) or the
switch on the elbow joint.
2) Rotate the terminal device once around its own axis until a slight resistance is felt (about
360°).
3) Overcome this resistance and pull the terminal device off the socket.
1. 2x powerful LEDs
1
to light the working environment
2. On/off switch
2
to turn the LEDs on/off
Switching on: Press the button to turn the LEDs on. If this button
is pressed immediately after switching on, the brightness can be
3
changed in 3 levels by pressing it again.
Switching off: About 5 seconds after switching on, press the
button again to turn the LEDs off.
After about 15 minutes, the torch is switched off automatically.
3. Battery compartment
See the next section for battery replacement
1) Turn the battery compartment cover counter-clockwise (e.g. with
a coin) until it is released from the battery compartment.
2) Remove the battery compartment cover.
3) Insert 2 CR2032 button cells with the + pole facing the cover.
4) Install the cover. In doing so, make sure the rubber seal is not
damaged.
5) Close the cover by turning it clockwise.
This safety function allows the prehensile arms to be opened regard­
less of the control signals.
► Swing the unlock lever away from the dial (arrow) and open the
prehensile arms manually.
23