Verifying And Monitoring Wccp Configuration Settings - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 81 Configuring WCCP Version 2 Services

Verifying and Monitoring WCCP Configuration Settings

To verify and monitor the configuration settings for WCCP, use the following commands in EXEC mode:
Command
Switch# show ip wccp [vrf vrf-name] [web-cache |
service-number]
For IPv6
Switch# show ipv6 wccp [vrf vrf-name]
Switch# show ip wccp [vrf vrf-name] {web-cache |
service-number} detail
For IPv6
Switch# show ipv6 wccp [vrf vrf-name] detail
Switch# show ip interface
Switch# show ip wccp [vrf vrf-name] {web-cache |
service-number} view
For IPV6
Switch# show ipv6 wccp [vrf vrf-name] view
WCCP Configuration Examples
This section provides the following configuration examples:
•
•
•
•
•
•
•
•
Example: Performing a General WCCP Configuration, page 81-10
Example: Running a Web Cache Service, page 81-10
Example: Running a Reverse Proxy Service, page 81-10
Example: Running TCP-Promiscuous Service, page 81-11
Example: Running Redirect Access List, page 81-12
Example: Using Access Lists, page 81-12
Example: Setting a Password for a Switch and Content Engines, page 81-13
Example: Verifying WCCP Settings, page 81-13
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Verifying and Monitoring WCCP Configuration Settings
Purpose
Displays global information related to WCCP, including
the protocol version that is currently running, the
number of content engines in the routers service group,
the content engine group is allowed to connect to the
device, and the access list being used.
Queries the device for information on which content
engines of a specific service group that the device has
detected. The information can be displayed for either
the web cache service or for the specified dynamic
service.
Displays the status about whether redirection
commands are configured on a client interface. For
example,
Web Cache Redirect is enabled /
.
disabled
Displays the devices in a particular service group that
have been detected and the content engines that are not
visible to all other devices to which the current device
is connected.
The view keyword indicates a list of addresses of the
service group. The information can be displayed for
either the web cache service or the specified dynamic
service.
For further troubleshooting information, use the
Note
show ip wccp {web-cache | service number}
service command.
81-9