Monitoring The Interface Configuration; Configuration Examples For Access And Trunk Port Mode - Cisco Nexus 1000V Configuration Manual

Monitoring the Interface Configuration

Command
show interface ethernet slot/port counters [ brief |
detailed | errors | snmp | storm-control | trunk]
show interface ethernet slot/port status
[err-disable]
show interface brief
show interface switchport
show interface trunk [module module-number | vlan
vlan-id]
show interface capabilities
show running-config interface ethernet slot/port

Monitoring the Interface Configuration

Use one of the following commands to display access and trunk interface configuration information:
Command
clear counters [ interface ]
show interface counters [ module module ]
show interface counters detailed [ all ]
show interface counters errors [ module module]

Configuration Examples for Access and Trunk Port Mode

This example shows how to configure a Layer 2 access interface and assign the access VLAN for that interface:
switch# configure terminal
switch(config)# interface ethernet 2/30
switch(config-if)# switchport
switch(config-if)# switchport mode access
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x
32
Configuring Layer 2 Interfaces
Purpose
Displays the counters for a specified Ethernet
interface.
Displays the status for a specified Ethernet interface.
Displays interface configuration information,
including the mode.
Displays information about the access and trunk
interface for all Layer 2 interfaces.
Displays trunk configuration information.
Displays information about the capabilities of the
interfaces.
Displays configuration information about the specified
interface.
Purpose
Clears the counters.
Displays input and output octets unicast packets,
multicast packets, and broadcast packets.
Displays input packets, bytes, and multicast as well
as output packets and bytes.
Displays information on the number of error packets.