Table of Contents
Advertisement
6.3.2.1 Safety instructions
CAUTION
Screw connections not tightened
Pinching, crushing, tipping over, falling of user due to assembly errors
► After all adjusting/readjusting work authorised by the manufacturer, retighten the mounting screws/nuts firmly.
Observe any torque settings which may be specified.
6.3.2.2 Adjusting the control device
WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified personnel. The manufacturer of the product and the control
device manufacturer are not liable in case of damage caused by programming which was not performed prop
erly and/or which was not adjusted properly according to the user's abilities.
If necessary, the qualified personnel can adapt the preprogrammed wheelchair control unit and options to the con
crete requirements of the user.
7 Delivery
7.1 Final inspection
A final inspection must be performed before delivery of the power wheelchair:
•
Was the product fitted optimally to the physical and mental condition of the user (e.g. seat, arm support/side
panel, leg supports, control panel)?
•
Are the batteries charged?
•
Is the tyre pressure correct (see tyre sidewall and the section "Technical data" for information)?
•
Do all manual and power functions work properly?
•
Do all control functions work properly?
•
Do the brakes work?
7.2 Transport to the customer
Instructions for disassembly and transport: see Page 57.
7.3 Handing over the product
WARNING
Lack of instruction
Tipping over, falling of the user due to lack of knowledge
► Instruct the user or the attendant in the proper use of the product when handing it over.
The following steps must be performed for the safe handover of the product:
•
Have the user get into the product and perform a trial seat fitting. Pay special attention to proper positioning
according to medical considerations.
•
The user and any attendants must be instructed in the safe use of the product. The instructions for use in par
ticular have to be used.
•
The instructions for use must be given to the user or an attendant upon delivery of the wheelchair.
•
The user or attendant should acknowledge that they have been instructed in how to use the product and were
informed of the residual risks.
Depending on equipment: The supplied instructions for use for accessories have to be handed over in addi
•
tion.
Skippi Plus
Delivery
19
Advertisement
Table of Contents
