Behaviour In Case Of Breakdowns; Disposal; Safety Instructions; Disposal Information - Otto Bock Skippi Plus Instructions For Use Manual

Disposal

LED
Backrest LED is flashing
Seat surface LED is flash­
ing
2 LED's below the seat
surface are flashing
Backrest/seat bottom LED
is flashing

9.4 Behaviour in case of breakdowns

In case of breakdowns, promptly inform the qualified personnel that adapted the product or the manufacturer's ser­
vice (see inside back cover or back page for addresses). All relevant details have to be provided, such as the type
of power wheelchair, type of breakdown (e.g. problems with the motor) and if possible, the serial number of the
power wheelchair.
To get help faster, noting the address and telephone number of the responsible specialist dealer in the field
provided on the back of these instructions for use is recommended. This information should be kept on hand,
especially when driving outdoors.
10 Disposal

10.1 Safety instructions

NOTICE
Disposal of batteries
Pollution due to incorrect disposal
► Observe the information printed on the batteries by the manufacturer.
► Note that the batteries may not be disposed of as household waste.

10.2 Disposal information

Return the product to the qualified personnel for disposal.
Defective batteries are taken back by the qualified personnel in exchange when new batteries are purchased.
All components of the product must be disposed of properly in accordance with the respective national environ­
mental regulations.

10.3 Information on re-use

CAUTION
Used seat padding
Functional and/or hygienic risks due to re-use
► Replace the seat padding if the wheelchair is to be re-used.
The product is suitable for re-use.
Similar to second-hand machines or vehicles, products that are being re-used are subject to increased strain. Fea­
tures and performance must not change in a way that could impair the safety of users or third parties during the
period of use.
The relevant product must be thoroughly cleaned and disinfected before re-use. Then have the product inspected
by qualified personnel with respect to its condition, wear and tear, and damage. Worn and damaged parts as well
as components that do not fit or are unsuitable for the user must be replaced.
Detailed information on replacing components as well as information on the required tools can be found in the ser­
vice manual.

11 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
70
Error/warning
Back angle adjustment
motor fault
Seat tilt motor fault
Seat height adjustment
motor fault
Power seat function tem­
perature warning
Cause
Faulty cabling or plug con­
tact
Defective actuator
Faulty cabling or plug con­
tact
Defective actuator
Faulty cabling or plug con­
tact
Defective actuator
Overheating due to excess­
ive load
Possible measure
Check cabling/plug con­
tacts
Contact specialist dealer
Check cabling/plug con­
tacts
Contact specialist dealer
Check cabling/plug con­
tacts
Contact specialist dealer
Cool down phase
Skippi Plus