Table of Contents
Advertisement
53
54
Information on correct transport safety of the user in the vehicle for transporting persons with reduced
mobility
•
Using the personal restraint system of the vehicle for transporting persons with reduced mobility is required. If
the wheelchair is equipped with a fixation kit (anchor point adapters), the three-point personal restraint system
is attached in the vehicle for transporting persons with reduced mobility as follows:
–
The lap belt of the personal restraint system is usually attached by the qualified personnel to the left and
right sides respectively on the mounting point/pin of the anchor point adapters.
–
The shoulder harness of the personal restraint system is usually mounted on the vehicle pillar and is
attached by the qualified personnel to the corresponding mounting point/pin provided on the lap belt.
55
Placement of the personal restraint system integrated in the vehicle for transporting persons with
reduced mobility
Fastening the restraint lap belt of the vehicle for transporting persons with reduced mobility is mandatory.
The power wheelchair's lap belt should be used in addition to position the passenger during transportation.
Skippi Plus
Applying the front attachment straps
1) Hook each of the front attachment straps into its
corresponding front anchor point from the outside
(see fig. 53).
2) Tighten the front attachment straps.
Applying the rear attachment straps
1) Hook each of the rear attachment straps into its cor
responding rear anchor point from below (see
fig. 54).
2) Tighten the rear attachment straps.
•
The straps of the personal restraint system must
always be routed close to the user's body. The
straps must not be routed over the side panels and
wheels (see fig. 55 item 2).
•
The shoulder harness must always be routed over
the user's shoulder. The qualified personnel must
secure the shoulder harness above and behind the
user (see fig. 55, item 1).
•
The belt strap must not be twisted on the user's
body.
•
The wheelchair restraint belts secured to the vehicle
floor must be stretched as taut as possible once
they are attached.
Use
61
Advertisement
Table of Contents
