Chapter 12
Field-Replaceable Unit Guide
c.
Replacing the Camera Cluster—Part Number
CTS3K-CAM-CLST-G2=
Required Information, Tools, and Equipment
To remove and replace the camera cluster for the Cisco TelePresence 3200, you need the following
information, tools, and equipment:
•
•
•
•
•
•
•
•
Removing and Replacing the Camera Cluster
Make sure to retain all screws, brackets, and other parts during the disassembly.
Note
Take care not to scratch or mar the display screen during the replacement procedure.
Caution
The directions left and right refer to the assembly as you face it.
Note
Power off the system by completing turning off the following units:
Step 1
•
•
•
OL-14521-01
In the Use Configuration TFTP Server area, click Automatic to set TFTP conditions to their default
value and remove any alternate TFTP servers.
Cisco TelePresence System Release 1.4 Administrator's Guide, OL-13676-03
Release Notes for Cisco TelePresence System, Release 1.4, OL-12074-05
Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
0.9mm Allen wrench for camera lens adjustments (if the lens uses a thumbscrew, no tools are
required)
Manual screwdrivers, Phillips and flat head types
Metric wrenches, 10 to 15 mm
Masking tape
Laptop computer attached to network
The two left PDUs on the left accessory cabinet
The single right PDU on the right accessory cabinet
The auxiliary control unit on the center display structure
Replacing the Camera Cluster—Part Number CTS3K-CAM-CLST-G2=
Cisco TelePresence System 3200
12-5