Cisco 3200 Use And Care Manual page 142

Parts List
Step 3 Attach the projector to the projector mounting bracket, and attach the assembly to the underside of the
center Table segment.
Note •
•
Figure 8-3 Projector Assembly
Cisco TelePresence System 3200
8-6
The bracket slides between two rows of screws. Screw the six screws with washers into the underside
of the center table segment and slide the bracket between the two rows of screws; then, tighten the
screws.
There is a channel that is cut into the underside of the table. Route the cable for the center
microphone into this channel, using tape if required, so that the microphone cable is not pinched
between the bracket and the table.
Chapter 8 Assembling the Remaining Cisco TelePresence Elements
1
2
6
4
OL-14521-01