Replacing A Microphone With A Microphone Extension Cable - Cisco 3200 Use And Care Manual

Replacing a Microphone—Part Number CTS-MIC=
Step 3 From the underside of the tabletop, remove the two screws and washers that secure the microphone.
Retain the screws and washers.
Note
Disconnect the microphone from the codec or audio/video extension unit.
Step 4
Pull the cable out through the hole and set the microphone aside.
Step 5
If the microphone is a second row microphone, you might have to disconnect some cable ties between
Note
the cable and the audio/video extension unit.
Pull the replacement microphone cable through the hole in the tabletop.
Step 6
From the underside of the tabletop, attach the microphone by screwing in the two screws.
Step 7
Run the microphone cable to the codec or audio/video extension cable in a similar manner as the original
Step 8
cable and attach it to the appropriate connection on the codec or audio/video extension unit.
Power on the system by turning the power switches to the On position on the two left PDUs, single right
Step 9
PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.
Open a browser on a computer connected to the network.
Step 10
Type in the IP address of the Primary codec. Enter the required information at the login screen. The
Step 11
Cisco TelePresence Administrator window appears.
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
Step 12
window) is Enabled/Up.
Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
Step 13
properly.
Refer to the
information.
Step 14 If required, reattach the projector assembly.
See
Step 15 Perform the microphone test to verify that the microphone is working properly.
See the

Replacing a Microphone With a Microphone Extension Cable

If your microphone uses a microphone extension cable between the codec or audio/video extension unit
and the microphone, complete the following procedure to replace the microphone.
If you are replacing a first row left or right microphone, or a second row microphone, skip to
Step 1
If you are replacing the center microphone, follow these steps.
Step 2
a.
b.
Cisco TelePresence System 3200
12-20
Cisco TelePresence System Administrator's Guide
Chapter 8, "Assembling the Remaining Cisco TelePresence Elements"
"Setting Up the Microphones" section on page 10-18
Loosen, but don't remove, the mounting screws holding the projector assembly to the underside of
the center tabletop.
Remove the projector assembly by sliding the unit to the left and away from the mounting screws.
Chapter 12 Field-Replaceable Unit Guide
for your software release for more
for more information.
for more information.
Step 3.
OL-14521-01