Replacing A Microphone-Part Number Cts-Mic; Required Information, Tools, And Equipment; Powering Off The System - Cisco 3200 Use And Care Manual

Replacing a Microphone—Part Number CTS-MIC=
Step 16 Power on the system by completing the steps in the
Refer to the
information.
Perform the Auto Adjust camera setup procedure. This sets the white balance to the correct levels. See
Step 17
the
If you are replacing the primary codec, power it on and complete all steps before powering on the
Note
secondary codecs. This prevents the secondary codecs from being affected by any software and
peripheral upgrades to the primary codec.
Replacing a Microphone—Part Number CTS-MIC=

Required Information, Tools, and Equipment

To remove and replace a microphone for the Cisco TelePresence 3200, you need the following
information, tools, and equipment:
•
•
Tip
•
•
•
•
•
Make sure all system power is turned off before beginning this disassembly.
Caution

Powering Off the System

Power off the system by turning the power switches to the Off position on the two left PDUs, single right
PDU and, if present, the PDU or auxiliary control unit behind the center display assembly.
Make sure all system power is turned off before beginning this disassembly.
Caution
Cisco TelePresence System 3200
12-18
Cisco TelePresence System Administrator's Guide
"Setting Up the Cameras" section on page 10-6
Cisco TelePresence System Release 1.4 Administrator's Guide, OL-13676-03
Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
A round-head Allen bit allows the bit to work at an angle instead of only straight out, which is
helpful in tight spots.
Manual screwdrivers, Phillips and flat head types
Metric wrenches, 10 to 15 mm
Masking tape
Laptop computer attached to the network
Knife or cutting tool (to disconnect cable ties for a second row microphone)
Chapter 12
"Powering On the System" section on page
for your software release for more
for detailed instructions.
Field-Replaceable Unit Guide
12-4.
OL-14521-01