Power Requirements For The Cisco Telepresence 3200 - Cisco 3200 Use And Care Manual

Power Requirements for the Cisco TelePresence 3200

Do not power on the PDUs until you route and connect all the cables.
Caution
Use care when you route the power cables from the PDUs. Do not bend the cables immediately after they
Caution
exit the PDUs and be sure that the cable does not pull on, or cause any strain to, the PDU socket and
power cord plug connection. Incorrectly routed cables can cause undue stress to the PDU receptacle and
the power cord plug.
Warning Overcurrent protection is provided by branch circuit protection rated 20A.
Output receptacles cannot exceed 15A for any one receptacle.
Warning
Power Requirements for the Cisco TelePresence 3200
Table 9-1
Correct routing of the various power cords to the PDUs and auxiliary control unit is critical for the safety
Caution
and success of the Cisco TelePresence 3200. Route each power unit to a different 20 amp circuit to
prevent circuit overload when all the electrical components are properly installed.
Table 9-1 PDU and Auxiliary Control Unit Locations and Power Requirements
Left PDU 1
(Located on Left Accessory Cabinet)
Right PDU
(Located on Right Accessory Cabinet)
Auxiliary Control Unit
(Located on rear of display structure)
First Row Table PDU
(Located above the projector under the Center table segment)
Second Row Table left-center PDU
Second Row Table right-center PDU
Cisco TelePresence System 3200
9-2
provides the power requirements and PDU locations for the Cisco TelePresence 3200 system.
Chapter 9 Routing Power and Signal Cables
AC wall outlet
20 amps @100-120volts
or 10 amps @ 230-240 volts
AC wall outlet
20 amps @100-120volts
or 10 amps @ 230-240 volts
AC wall outlet
20 amps @100-120volts
or 10 amps @ 230-240 volts
AC wall outlet
20 amps @100-120volts
or 10 amps @ 230-240 volts
20A AC wall outlet
20A AC wall outlet
OL-14521-01