Powering On The System - Cisco 3200 Use And Care Manual

Powering On the System

Table 12-1 List of FIeld-Replaceable Units for the Cisco TelePresence System (continued)
FRU Part Number
CTS-PRJTR-JC-GEN1=
CTS-PWR-PDU=

Powering On the System

Use this procedure for sections in this chapter that require you to power on the system.
If you replaced the primary codec, reconfigure the codec for the new MAC address in
Step 1
Cisco Unified Communications Manager by performing the following actions:
a.
b.
Power on the Cisco TelePresence 3200 by turning the power switches to the On position on the two left
Step 2
PDUs, single right PDU, and auxiliary control unit.
Six check boxes display on the lower left corner of the center display screen.
Step 3 Wait while the system checks each check box and clears the screen.
The system IP address displays on the lower right corner of the center display screen.
Write down the IP address. This is the address of the primary codec.
Step 4
Log in to the system by entering the following information:
Step 5
a.
b.
Note
Click Login.
Step 6
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
Step 7
window) is Enabled/Up.
Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
Step 8
properly.
If you are replacing a primary codec, perform the following steps:
Step 9
Note
a.
b.
Cisco TelePresence System 3200
12-4
Description
Jumper Cord From the projector
Power Distribution Unit for the Cisco TelePresence Systems
Log in to Cisco Unified Communications Manager.
Change the device MAC address to the MAC address for the new primary codec. The MAC address
should be displayed on the codec.
In the Admin field, type admin.
In the Password field, type cisco.
If your administrator has changed the user name or password, enter those values.
If you are not replacing a primary codec, do not perform the following steps.
Navigate to the Device Information > Configuration > CUCM settings window, then perform the
following actions:
In the Certificate Trust List (CTL) area, delete the CTL from your system by clicking Delete CTL.
Chapter 12 Field-Replaceable Unit Guide
OL-14521-01