Cisco 3200 Use And Care Manual page 243

Chapter 12 Field-Replaceable Unit Guide
Step 28 Attach the privacy panel hangers to the table legs that support each side of the table top section.
See Chapter 7, "Building the Second Row Table Assembly"
attachment points and screw locations.
Attach the privacy panel alignment bracket.
Step 29
See Chapter 7, "Building the Second Row Table Assembly"
brackets.
Step 30 If you are replacing the left or right tabletop end, attach the privacy panel end pieces and panel end brace.
See Figure 7-47
Step 31 Insert the microphone cable into the hole in the table top and route the cable through the cable gutters
to the audio/video extension unit.
Connect the microphone cable to the audio/video extension unit.
Step 32
Step 33 Reconnect the microphone to the new table top section.
See Figure 7-38
Attach the privacy panels to the table sections.
Step 34
Note
Step 35 If required, replace the cable cover for the right end privacy panel as shown in
ties to bundle the microphone cable with other cables.
Step 36 Reposition the second row table so that the trailing edge of the first row table is exactly 59 inches
(150 cm) behind the leading edge of the second row table. See
table positioning.
OL-14521-01
for the privacy panel end piece locations and
for microphone installation instructions.
If required, adjust the privacy panel sections so that there is an equal amount of space between
each section.
Replacing a Second Row Table Top Section
for the privacy panel support bracket
for the location of the privacy panel support
Figure 7-30 for the end brace locations.
Figure 7-46
Figure 7-48 for the correct second row
Cisco TelePresence System 3200
and add cable
12-35