Cisco 3200 Use And Care Manual page 242

Replacing a Second Row Table Top Section
Step 12 Move one of the table legs to allow access to the draw bolts or cam locks and remove the draw bolts or
cam locks from the adjoining table top sections. See
Assembly"
Note Make sure that the leg still supports both table top sections.
Step 13 If you are replacing an end piece, remove the attachment plates.
Step 14 If required, reposition the table leg so that it fully supports both table sections.
Step 15 Move the table leg on the other side of the table top to allow access to the draw bolts or cam locks and
remove the draw bolts or cam locks from the adjoining table top sections.
Note Make sure that the leg still supports both table top sections.
Step 16 Separate the table top sections to create a space between the section to be replaced of approximately one
inch (2.5 centimeters); this step allows you to remove the splines between the table top sections.
To ease movement of the sections, you can place furniture sliders under each table leg before you move
Tip
the sections.
Be sure that the legs support all table top sections and do not allow any of the sections to fall to the
Caution
ground.
Step 17 Remove the splines from the slot in the edges of the table top section.
Step 18 Remove the table top section to be replaced.
Step 19 Place the new table top section on the table legs.
Place the splines in the slots on the edge of the new table top section.
Step 20
Press the table top sections together.
Step 21
Insert the draw bolts or cam locks and tighten them between the new table top section and the adjoining
Step 22
table top sections. See
draw bolts or cam locks.
Step 23 If you are replacing an end piece, insert and attach the attachment plates.
Attach the legs to the table top sections with the screws. See
Step 24
Assembly"
Step 25 Attach the gutter and privacy panel support brackets to the table assembly.
See Chapter 7, "Building the Second Row Table Assembly"
bracket attachment points and screw locations.
Step 26 Attach the gutter panel for the table top section.
See Chapter 7, "Building the Second Row Table Assembly"
screw locations.
Step 27 Attach the floating bracket on each side of the table top section.
See Chapter 7, "Building the Second Row Table Assembly"
and screw locations.
Cisco TelePresence System 3200
12-34
for the location of the draw bolts or cam locks.
Chapter 7, "Building the Second Row Table Assembly"
for the location of the table legs and screw attachment locations.
Chapter 12 Field-Replaceable Unit Guide
Chapter 7, "Building the Second Row Table
Chapter 6, "Building the First Row Table
for the gutter and privacy panel support
for the gutter panel attachment points and
for the floating bracket attachment points
for the location of the
OL-14521-01