Cisco 3200 Use And Care Manual page 203

Chapter 10 First-Time Setup
The projector takes approximately 15-30 seconds to warm up, and should be fully initialized within one
minute. If the projector is not receiving video, the screen will be blue. If the projector does not receive
video for five minutes and 30 seconds, the projector turns off.
If the test pattern is displaying correctly, you should see a grid projected on the projection surface. In
the center of the grid, you should see a series of horizontal grey bars. You should also see a one-pixel
wide green border around the outside of the grid.
From Cisco TelePresence System Administration, click Set Projector Defaults to automatically
Step 4
configure the projector for use with the CTS 3200.
Set the group, number and data settings by completing the following steps:
Step 5
Changing these settings allows a projector to be monitored by the System Network Management
Note
Protocol (SNMP) when the projector is in an inactive state. If a projector lamp fails, SNMP does not
properly report the failure from an inactive projector until you complete these steps.
Tip Use the projector remote control or press the buttons on the projector to complete these steps.
Note If your system uses a Sanyo PLV-Z700 projector, skip this step.
a. Press the Menu key for 20 seconds.
The letter S displays in the upper left corner of the screen.
Press the Screen key for 3 seconds.
b.
The service menu displays.
Press OK until the group number setting changes to 100.
c.
Press the Down Arrow key until the No. setting changes to 4.
d.
Press the Left Arrow key until the Data setting changes to 0.
e.
Press the ON-OFF key to end the service menu.
f.
Center the projector display within the screen by completing the following steps:
Step 6
Locate the lock switch and two dials on the side of the projector.
a.
Move the switch to the unlock position.
b.
Rotate the vertical dial to position the top of the image 1 inch below the bottom of the wood surface.
c.
d. Rotate the horizontal dial to position the sides of the image 15 inches from each of the seams on the
table segments.
Completing this step should center the image in the screen. If the image is not centered, adjust the
image until the distance is equal from each table segment seam.
Move the switch to the lock position.
e.
Aim the remote control at the lens of the projector.
Step 7
You can use the screen to reflect the signal back to the projector if you are sitting at the table.
Tip
OL-14521-01
Setting Up CTS Components
Cisco TelePresence System 3200
10-21