Cisco 3200 Use And Care Manual page 192

Setting Up CTS Components
Figure 10-4
Figure 10-5 Correct Camera Target Alignment—Center Display
Note curved
lines touching
screen border
d.
e.
Cisco TelePresence System 3200
10-10
Camera Adjustment Screws
Left
adjust
screw
Camera
rotation
screw
Place the small target on the table in front of the large target, and adjust the focus by completing the
steps in the "Focusing the Camera" section on page
Remove the large target from the center part of the table, and attach it to the left part of the table,
placing the underside of the clamps into the recessed holes.
Right
adjust
screw
Camera
rotation
screw
Lens
Up/down
adjust
screw
10-12.
Chapter 10 First-Time Setup
Red plus
sign within
black cross
Red lines
Table
edge
OL-14521-01