Cisco 3200 Use And Care Manual page 219

Chapter 12 Field-Replaceable Unit Guide
Figure 12-2
Turn the power switch on the Plasma display to the On position.
Step 10
The rear of the replacement display will have either two HDMI connectors (see
Step 11
connectors (see
If the replacement display has two HDMI connectors, connect your existing signal cable to the codec
and to the left-most HDMI connector on the rear of the display (as viewed from the rear of the display),
as shown in
If the replacement display has two DVI connectors, connect the signal cable supplied with the
replacement display to the codec and to the left-most connector on the rear of the display (as viewed
from the rear of the display), as shown in
OL-14521-01
Attaching the Display Mounting Bracket
Figure 12-4).
Figure 12-3.
Replacing a Plasma Display—Part Number CTS-DISP-65-GEN4=
Figure 12-4.
Cisco TelePresence System 3200
Figure 12-3) or two DVI
12-11