Cisco 3200 Use And Care Manual page 160

Power Requirements for the Cisco TelePresence 3200
Step 4 Route the power cables for the first row table assembly.
Figure 9-4 First Row Table Assembly Cable Routing
8
9
The six jumper cords from the I/O modules in the table legs route to the center PDU.
Note
Before plugging the Table leg jumper cords into the Table PDU, label each one. For example, Outer Left
Tip
Power, Inner Right Power.
Cisco TelePresence System 3200
9-6
Table Leg Power
Projector Power
Chapter 9 Routing Power and Signal Cables
OL-14521-01