Power Requirements for the Cisco TelePresence 3200
Step 11
Connect the following cables to the auxiliary control unit:
•
•
•
•
Figure 9-11
Cabling the Lighting Assembly Power Cables and Auxiliary Control Unit-to-Projector Serial Cable
Power
Projector
RJ45 Ethernet
Before plugging the Light fixture power cables into the unit, label each one. For example, 5' Left light,
Tip
4' Right light.
Cisco TelePresence System 3200
9-14
Attach and route the power cables for the lighting assembly by connecting the lights to the auxiliary
control unit.
Connect the DSUB to 8-P MINI DIN cable between the projector and the auxiliary control unit.
Connect the Ethernet cables between the codec and the auxiliary control unit.
Connect the power cord for the auxiliary control unit to a wall outlet.
Auxiliary Control Unit
Auxiliary Control Unit
Auxiliary Control Unit
1
2
SERI AL PORTS
1
2
RESET
10/ 100 NETW ORK PORTS
Primary Codec
Chapter 9
Routing Power and Signal Cables
OL-14521-01